Schaublin_Catalogue
Page - Seite 6.3
Tolérances de battement radial des pinces de serrage avec alésage profilé Rundlauftoleranzen von Spannzangen mit Profil-Bohrung Radial runout tolerances (concentricity) for collets with profiled bores
maxi
Diamètre passant outre
D
Durchgangsbohrung
Through bore
L
(Longueur de portée ≤ 1 x D) Pince avec épaulement ou cran
maxi
D
Spannzange mit Stufenbohrung (Spannlänge ≤ 1 x D)
(Bore length ≤ 1 x D) Collet with stepped bore
5
Remarques
Ces valeurs se rapportent à la pince et ne prennent pas en compte les caractéristiques de l'application. Les pinces "A" ne sont pas concernées par cette tabelle. Les battements indiqués sont valables pour le serrage sur toute la longueur de l'alésage
Bemerkungen
Diese Werte beziehen sich auf die Spannzange und berücksichtigen die Eigenschaften der Anwendung nicht. Für Vorschubzangen Typ "A" ist diese Tabelle ungültig. Die angegebenen Werte gelten für die Spannung auf der gesamten Bohrungslänge
Remarks
These values are for the collets only and do not take into consideration the characteristics of the application. This table does not apply to A-type collets (feedfingers). The indicated values are valid for clamping on the entire bore length.
D
L
maxi
maxi
Alésage Bohrung Bore
Standard
UP
au-dessus
jusqu'à
Ultraprécision
over über
bis
Highest precision Profil standard Höchstpräzision Standard profile Standard Profil
up to
Standard profile Standard Profil Profil standard
1.6
3
25 16 40 10 50 60 60
0.060 0.060 0.060 0.060 0.060 0.060 0.050
0.040 0.040 0.040 0.040 0.040 0.040 0.030
3
6 10 18 24 - 30
6 10 18 24 30
Copyright © 2017 SCHAUBLIN S.A., All Rights Reserved www.schaublin.ch 476-4800 Edition 01/2017
Made with FlippingBook HTML5